Thermal Twist Ball-Less Vape Titanium

Description

Titanium version

Removing the need for balls entirely we have designed this with vortex airflow and a metal core! Available in either SS316 Stainless Steel or Grade 2 Titanium. The Vortex airflow removes the need to stir your bowl when used with around 0.15, loads as the hot air does the work for you, removing one additional step while vaping! With larger loads you’ll want to stir every few inhales. Just load in a one SQP of herb, place the housing on the bowl, inhale, then watch it spin up and settle in to place! There’s no need to tamp your bowl as the airflow will do this for you too! Due to the spinning airflow the Thermal Twist also makes an excellent micro-doser, happily vaporizing down to around 0.05g (we haven’t tested with less… it would still vape less). From turning it give it 4-5 minutes for the housing to heat soak full before vaping, if you start sooner it will work but you’ll get very little vapor for the first few inhales as it heats. Please note that bubblers with restricted airflow may reduce the spinning action so we suggest more free flowing setups.

Designed with a simplified user experience in mind, the Thermal Twist comes fully set up with a handle installed on the heater coil and the housing fully set up, making for a plug and play experience without the possibility of spilling balls (as there are none) or mis-installing the handle during setup! Plug the heater into the front of the PID, the power adapter/plug into the back, turn it on, set your temp and it’s ready to go (initial burn off cycle advisable)! The Stand has been designed to provide minimal contact with the housing, meaning the heat stays where it should be, inside the housing and not being transferred into your stand, or worse, into the surface below!

Capable of providing anything between low temp terpy hits, to thick clouds. The Thermal Twist has fairly fast vapor production and exceptionally smooth vapor!

This kit comes with everything needed to get started, aside from a glass Rig or Bubbler (optionally available) and herb.

Suggested set temperature range on the PID: 300c-370c (572f-698f) but as with everything… use it as you like it! Though we wouldn’t advise going hotter as you might combust! We have customers who run this as low as 280C set temperature on the PID controller.

Titanium version provides slightly better flavour and is a lighter weight material